Instructions for the installer, maintenance
technician and final user
50
7.6 Cleaning of the Vending Machine
The general cleaning of the vendor must be done to maintain the efficiency of the vendor.
The following is recommended:
Check the vendor and the surrounding area, check for rust on the cabinet and
obstructions in the air vents
Open the vending machine door and check for accumulation of water , signs of rust,
and moisture around the edges of the door.
CAUTION: DO NOT USE WATER CLEANERS AND WATER JETS
7.7 Warnings
Before doing any cleaning operations on the machine pay particular attention to the
following indications:
Cut off power supply to the machine
Do not use blades or other sharp tools to scratch parts or components of the vendor
Do not clean the vending machine in areas under the sun or with high temperature
Disconnect power supply to the machine before cleaning electric parts and/or
protected by cover
The power plug must be positioned so that the operator can see and control it from
any position
Do not use cleaning products other than those recommended
When cleaning with liquid products disconnect the machine from the power main
ATTENTION: REMOVE THE DUST IN FRONT OF THE CONDENSER EVERY
THREE MONTHS
To Next Page
Loading...
Need help?
General
