Why is my Vendo Vending machine not cooling?
If your Vendo Vending machine is not cooling, first, ensure that the machine is receiving power by checking the power source. Secondly, inspect the power cable connections and fuses to rule out a communication failure between the power board and the vending machine. Also, verify that the communication cable is intact.
What to do if Vendo Vending machine returns coins?
If your Vendo Vending machine returns coins, start by checking the electric plug to ensure the machine is powered. Next, verify the coin box is powered by checking the connection wiring for faults and ensuring the fuse hasn't blown. If those are fine, inspect the coin box and levers for any issues. Lastly, a dirty money channel can cause this problem, so clean the coin box thoroughly with an approved detergent.
Why does the compressor work continuously in my Vendo Vending machine?
If the compressor in your Vendo Vending machine is running continuously, check the relay board and its wiring for any faults. Also, verify that the temperature setting is correct. Finally, inspect for gas leaks and, if found, reload the cooling system after repairing the leak.
What to do if Vendo Vending machine accepts coins but does not deliver product?
If coins are accepted by your Vendo Vending machine but no product is delivered, it might be due to several reasons. First, ensure the prices are correctly set. Second, check the connection wire between the coin box and the board for communication errors. If necessary, try replacing the coin box or the board. Lastly, make sure the motor is powered by 24V when a selection is made, and always cancel any errors on the board.
Why is the compressor not working in my Vendo Vending machine?
If the compressor in your Vendo Vending machine isn't working, check the overload protection or the compressor relay.
Why is the evaporator covered in ice in my Vendo Vending machine?
If the evaporator in your Vendo Vending machine is covered in ice, start by checking the evaporator fan. Also, inspect the cooling compartment's sealing and adjust the internal door closure. Ensure that the product door is not blocked.
How to fix the display that shows the sales counter on a Vendo Vending machine?
If your Vendo Vending machine shows the sales counter, adjust the position of the 'door closed' sensor.
What to do if the condenser fan works, but the compressor is old in Vendo Vending machine?
If the condenser fan is working but the compressor is old in your Vendo Vending machine, check that the compressor windings have the right electrical resistance and that the guide relay has control wiring. The relay board may be faulty.
Why are the sales not counted in my Vendo Vending machine?
If the sales made on your Vendo Vending machine are not being counted, adjust the door square and try a sale with the door closed to ensure the door switch activates when the door is closed.
Why does my Vendo Vending machine say sold out?
If your Vendo Vending machine has sold out, it could be because all columns are empty or the full columns have signaled a product blockage. Check that the full columns work properly with the manual test, and then reset the errors.
Explains the components and operation of the vending machine's cooling system.
Illustrates and names the parts of the vending mechanism responsible for product dispensing.
Provides essential instructions and cautions for safely moving and placing the vending machine.
Specifies suitable environmental conditions for installing the vending machine to ensure proper operation.
Details the procedure and safety checks for connecting the machine to the power supply.
Covers operational warnings, column setup, product loading, and conversion procedures.
Procedures for verifying machine readiness and initial power-on.
Instructions for cleaning the machine, recommended products, and general safety during cleaning.
Lists common issues, their causes, and recommended solutions for the vending machine.
General| Manufacturer | Vendo |
|---|---|
| Model | VDI 217 |
| Capacity | 217 |
| Voltage | 115V |
| Power Supply | 115V |
To Next Page
