6.2 Instructions
To ensure the long-term and effective operation of your battery
system,please observe the following rules;
Battery system temperature requirements
Operating temperature:-20℃-50℃
Storage ambient temperature:-30℃to 60℃
Optimum charge and discharge temperature:25℃-50℃
2.1 Battery Installation Procedure
Check the battery status and ensure that the power switch is off.
The installation personnel wear insulation gloves and lift/lift the battery into
the battery compartment.
Ensure that the discharge port and communication port are properly
connected and securely connected,turn on the battery power switch.
After the above steps and ststus are confirmed,the battery can be used
normally.
2.2 Check before driving
Please first confirm whether the emergency stop switch of vehicle is in
the closed state(avoid damaging the relay when the battery is on).
Observe the instrument panel and make sure that the battery is normal
and there is no alarm message.
When the SOC is greater than 50% and the state is good,it is recom-
mended to start with full battery.
When SOC is less than 30%,battery system power is low,charge at least
50%bafore running;
2.3 Requirements for Normal operation vehicles
If the battery level is lower than 30%,charge it immediately.It is recom-
mended that you use it after it is fully charged.
Do full power work at least once every two weeks.
Battery maintenance should be performed every two manths to prevent
damage to the battery system.See section 1.8 for specific maintenance
methods;
2.4 System Transportation and use Requirements
During loading,unloading and transportation,violent shaking and large
external impact should be avoided,and throwing,rolling,inverted and extru
To Next Page
Loading...
General