The maximum speed
slows down
(I) The battery is about to run out
(II) The hand brake is forgot to release or the brake shoes
are not reset
(III) The accelerator pedal is faulty
(IV) The controller is faulty
(V) Excessive load
(VI) The motor or controller is in temperature protection
state
(VII) Abnormal motor encoder
6.5 Brake part
1. Press the brake pedal with a force of about 30kgf, and the pedal stroke
shall not exceed 2/3 of the total stroke.
2. The brake pad clearance is automatically adjusted. Under the action of
20kgf pull, parking brake handle should be stuck in certain tooth between 5-
10 ratchets, and the wheel should be effectively locked. When the handle is
fully released and reset, the parking brake is released.
3. Regularly check and replace br
ake shoes and fill lubricating oil in brake
hub bear
ing.
6.6 Lubrication and maintenance of complete vehicle
1. The brake fluid used for ex-factory is Like 901 automobile brake fluid,
and it is forbidden to mix and use different brands of brake fluid.
2. 85W/90GL hypoid gear oil is used for gearbox and rear axle, and the
filling amount is 0.8L.
3. Main lubricating points: Fill butter in steering gear box, tie rod, steering
knuckle and bearing parts.
6.7
Running-in of new vehicle
To e
nsure the use performance of the vehicle, improve the reliability of
the complete vehicle and prolong the service life of the complete vehicle, the
parts should be subject to running-in before the vehicle works at the maximum
load. It is stipulated that the running-in period of new vehicle is one month or
1000 kilometers, which should be carried out according to the following
specifications:
1. Before the running-in of new v
ehicle, it is required to carefully check
the capacity
of oil, electrolyte and brake fluid. If it is insufficient, it should be
filled according to regulations; tyres should meet 205/50-10, and the air
To Next Page
Loading...
General