pressure should be 200-250kPa.
2. Try not to drive on the ring road.
3. Always check the fastening of connecting parts, and tighten them if
they are loose.
4. During the running-in period of new vehicle, the speed is controlled
within 15km/h.
Precautions:
1. Before driving, the parking brake must be put to the bottom to avoid
burning the brake pad.
2. Check the rear powertrain every three months and fill or replace gr
ease.
3. Check the w
ear of brake shoes every three months, and adjust and
replace them in time in case of any problem.
4. Check the fastening of electrical system once a month, especially the
connection between large current circuits, such as battery, motor and electric
control, and keep it in good condition. At the same time, the contact state of
the contact parts should be checked, any defect found should be corrected in
time, and dep
osited dust should be r
emoved in time.
5. As the electrical contact is not in good contact, it will heat up, so we
should usually pay attention to the heating state at the contact point.
6. When changing the fuse, check whether the rated current of the new
fuse is correct.
7. During maintenance and repair of the vehicle, in order to ensure safety,
the positive and negative power cables of the battery pack should be removed.
8. It is strictly forbidde
n to slam on the accelerator or inching the
accelerator f
requently, so as not to damage the accelerator and shorten the
service life of the electronic control gear.
9. It is strictly forbidden to add other liquids to the battery, such as battery
additives, mineral water, tap water, etc., and distilled water must be added.
10. Drive safely. It is forbidden to drive at high speed when going
downhill. Slow down when turning, and remind passengers t
o pull handrails
when tur
ning and going downhill to avoid safety accidents.
11. Children are strictly forbidden to play in the vehicle. Children should
sit in the middle position and be cared for by adults to avoid children falling
from the vehicle.
12. Please conduct regular maintenance according to the table below: