1. Install your pedals as per the manufacturer’s instructions.
2. Then check the tire pressure and inate as per the manufacturer’s
recommendation.
3. Adjust the saddle height as necessary, and torque the seatpost clamp bolt to 6
N.m using a torque wrench. Ensure the seat post minimum insertion depth of
10cm is achieved.
4. Put on your shoes and helmet and take your new bike out for a road test. Always
wear a helmet when you ride your bicycle.
5. Check the operation of the brakes, derailleurs, and steering.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD LEAD TO SERIOUS INJURY OR DEATH.
WARNING
FINAL CHECKS & ROAD TEST
24
ENJOY YOUR
NEW RIDE!
QUICK REFERENCE SPECS
SEAT POST
CLAMP
Torque Spec: 6 N.m.
Use a torque wrench with 5mm
hex attachment
Torque Spec: 10 N.m.
Use a 6mm Hex Tool
THRU
AXLES
Torque Spec: 5-6 N.m. depending
on stem make and model. Check
stem for torque spec indications or
check with manufacturer.
STEM
BOLTS
25-35 PSI
Adjust as conditions and
equipment allow
TIRE
PRESSURE
Max 700C x 48mm
Tire clearance varies based on
internal rim width
TIRE
SIZING
VENTUMRACING.COM
To Previous Page
Loading...
