Veolia Orion II 4000 User Manual

OPERATORS MANUAL
ORION II
Orion II 500-10000 Operators
Page 1 of 95
Manual Part no: DOMAON0100 Issue A
April 2008
ORION II
Operators Manual
Models 500 – 10000

Veolia Orion II 4000 Specifications

General

Brand	Veolia
Model	Orion II 4000
Category	Water Filtration Systems
Language	English

Summary

Health and Safety Recommendations

Key Hazard Identification

Identifies hazards like chemicals, electricity, pressure, hot surfaces, gases, and ventilation.

Introduction

3.2.1 Pre-treatment Systems

3.2.4 Purified Water System RO Section

Details the Reverse Osmosis stages, tanks, and pumps.

3.2.5 Purified Water System Deionising Section

Describes Degassing and Continuous Electrodeionisation (CEDI) processes.

Process Description

5.1 Pre-treatment Systems

5.4 Purified Water System RO Section

5.5 Purified Water System Deionisation Section

5.9 Cleaning In Place (CIP) & 5.10 Hot Water Sanitisation (HWS)

Outlines procedures for Cleaning-In-Place (CIP) and Hot Water Sanitisation (HWS).

Control System

6.1 Operator Interface and Navigation

Details the HMI, screen layout, device colours, and access levels.

6.3 System Cleaning Routines

6.4 System Configuration Settings

Covers settings for Service, HWS, CIP, Analogue, Options, and Users.

6.6 Command Buttons, Status, and Alarms

Explains command buttons, status indicators, and alarm handling.

6.8 Alarm Definitions

Lists and describes fatal and warning alarms for system troubleshooting.

6.9 Access Levels

Plant Operation

7.1 Operating Modes & 7.2 Startup/Shutdown

Covers system operation modes and the routine start-up/shutdown procedure.

7.3 Plant Monitoring and Sampling

RO Membrane Cleaning

8.1 General RO Membrane Care

8.2 Corrected Flux (CF) Calculation

8.3 RO Cleaning Procedure

Provides safety notes and step-by-step instructions for RO cleaning.