4 5
• To avoid electrocution, do not operate this device near water.
• Close supervision is recommended when these lamps are used by or near children,
or others who may not understand the need for these precautions.
• To prevent risk of shock or personal injury when cleaning lamp, make sure you
have turned off and unplugged the lamp and allowed sufficient time for the lamp to
cool.
• Do not shorten or cut the power cord.
• Certain medications (e.g., anti-depressants) and diagnosed mental health
conditions may induce light sensitivity, which may result in discomfort, hyperactivity
or hypomania. Consult with your healthcare provider before using this product.
• If you have a pre-existing eye condition or are at risk for developing Age Related
Macular Degeneration or other eye conditions, consult with your healthcare
provider before using this product.
• Some people experience light sensitivity to bright light or upon over-exposure to
bright light. Discontinue use if you experience any discomfort.
• This lamp is for indoor use on a hard surface (e.g., a table or desk) only.
• Do not operate this lamp if it has been damaged in any way.
• Do not disassemble. There are no user-serviceable parts in this lamp.
• Use only the power adapter supplied with your lamp. If other power plugs, cords or
connectors are used, damage to your lamp or power adapter may occur.
• This lamp may cause interference with radios, cordless telephones or devices that
use a wireless remote control, such as televisions. If interference occurs, move the
lamp away from the device, plug the lamp or the device into a different outlet or
move the lamp out of the line of sight of the remote control receiver.
†
• This lamp is not for use with light dimmers, timers, motion detectors or voltage
transformers.
Important Safeguards
READ ALL INSTRUCTIONS BEFORE USING
†
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.”
This Class B digital apparatus complies with Canadian ICES-005.
1
2
Setup – Remove Stand
Setup – Afx Stand - vertical
• Stand affixed to back of lamp
• To remove stand – slide stand downward to
remove from keyhole
Affix stand by clipping
to bottom left or bottom
right — as shown.
vertical position
Important Safeguards — continued
Setup and Take Device Pretest
SAVE THESE INSTRUCTIONS
• Use a quality surge suppressor on all electronic equipment. Voltage variations and
spikes can damage electronic components in any system. A quality suppressor
can eliminate the vast majority of failures attributed to surges. Suppressors may be
purchased at electronics stores.
• Never cover the lamp or place anything on top of it when it is in operation.
— continued
Affix to indentations for
secure position
To Next Page
Loading...
