Verilux HappyLight Touch Plus - Setup and Device Preparation; Stand Removal and Attachment

Important Safeguards — continued
Setup and Take Device Pretest
SAVE THESE INSTRUCTIONS
• Use a quality surge suppressor on all electronic equipment. Voltage variations and
spikes can damage electronic components in any system. A quality suppressor
can eliminate the vast majority of failures attributed to surges. Suppressors may be
purchased at electronics stores.
• Never cover the lamp or place anything on top of it when it is in operation.
— continued
CAUTION:
1
2
Setup – Remove Stand
Setup – Affix Stand
• The stand is affixed to the back of the
HappyLight
®
Therapy Lamp
• To remove stand, slide stand upward to remove
from keyhole
Affix stand by inserting tabs on
stand into slots at base of lamp
and pressing together.
slots
tabs
4
VT42_MAN_Rev5-002.indd 4VT42_MAN_Rev5-002.indd 4 2/21/20 4:48 PM2/21/20 4:48 PM