8
Bulb Removal and Replacement
Figure 3
Step 1: Opening the Lens Cover
Place the HappyLight on its back
on a large flat surface. Press down
gently on the center of the lens
cover (Fig. 1). This releases the
locking tabs located under the
grey handles. Open the lens cover
by grasping the gray handles with
your hands. Remove the lens and
gently place it next to the unit with
the logo face up.
Figure 1
Step 2: Opening the Bulb Clips
Locate the clear plastic clips across
each fluorescent tube (Fig. 2). Put a
finger under the clear plastic clip on
the outer side and pull up (Fig. 3). The
clip should pop open. Repeat on other
side.
Figure 2
Clips
To Next Page
Loading...
