The WPS button is used to initiate Wi-Fi Protected Setup. This is an easy way to add WPS capable
devices to your wireless network. To activate the WPS function, press and hold the unified button
located on the front of your Fios Home Router for more than two seconds. When WPS is initiated from
your router, the Router Status
LED slowly flashes blue for up to two minutes, allowing time to complete the WPS pairing process on
your wireless device (also known as a wireless client). When a device begins connecting to your router
using WPS, the Router Status LED rapidly flashes blue for a few seconds, and turns solid blue and then
solid white as the connection completes.
If there is an error during the WPS pairing process, the Router Status LED slowly flashes red for two
minutes after the error occurs.
Refer to the “Connecting A Wi-Fi Device Using WPS” for more details. In addition, the unified button
also provides a quick view of the operational state of the Fios Home Router using various colors as
indicated in the chart above. Please refer to section 9.0h for details on the rear LEDs.
1.3b/ REAR PANEL
The rear panel of your router has a label that contains important information about your device,
including the default settings for the router’s wireless network name (SSID), wireless password (WPA2
key), local URL for accessing the router’s administrative pages, and administrator password. The label
also contains a QR code that you can scan with your smartphone, tablet, or other camera equipped
Wi-Fi device to allow you to automatically connect your device to your Wi-Fi network without typing in
a password (requires a QR code reading app with support for Wi-Fi QR codes).
The rear panel has seven ports; F-type coax, Ethernet LAN (four), Ethernet WAN, and USB. The rear
panel also includes a DC power jack and a reset button.
To Next Page
Loading...
