Vermont Castings LHECDV30 User Manual (English)

Other manuals for Vermont Castings LHECDV30

Homeowner's Installation And Operating Manual32 pages

Questions and Answers:

R
Reginald WigginsJul 30, 2025
Why won't the pilot light stay lit on my Vermont Castings LHECDV30 Indoor Fireplace?
- J
  Julie TaylorJul 31, 2025
  If the pilot light on your Vermont Castings Indoor Fireplace won't stay lit after you've followed the lighting instructions, there could be a few reasons. One possibility is a defective pilot generator (thermocouple) or remote wall switch. Make sure the pilot flame is properly hitting the thermocouple/thermopile. Try cleaning or adjusting the pilot for the best flame impingement on both the thermopile and thermocouple. Another cause could be a defective automatic valve. In this case, turn the valve knob to 'Pilot' and check that the milivolt meter reads above 10 mV while maintaining flow to the pilot. If the reading is good but the pilot still won't stay on, the gas valve may need to be replaced. Note: An interrupter block (not supplied) must be used to conduct this test.
M
Mrs. Julie BarberAug 15, 2025
Why does my Vermont Castings LHECDV30 Indoor Fireplace have frequent pilot outage problem?
- B
  brenda61Aug 15, 2025
  If you're having frequent pilot outages with your Vermont Castings Indoor Fireplace, it could be due to a few reasons. The pilot flame might be too low or too high, causing the pilot safety to drop out. Try cleaning and adjusting the pilot flame to make sure it hits the thermopile and thermocouple properly. Another possible cause is a blockage in the vent terminal. Check the vent terminal to ensure it's not blocked, as this can recycle flue gases.
C
Crystal EvansAug 21, 2025
How to fix spark ignitor that will not light on Vermont Castings LHECDV30?
- C
  Christina AndersonAug 21, 2025
  If the spark ignitor on your Vermont Castings Indoor Fireplace isn't lighting, it could be due to a defective or misaligned electrode at the pilot. Try lighting the pilot with a match. If it lights, turn off the pilot and push the red button again. If the pilot still won't light, check the gap at the electrode and pilot; it should be 1/8" to have a strong spark. Another possibility is a defective ignitor (push button). Push the piezo ignitor button and check for a spark at the electrode and pilot. If there's no spark and the electrode wire is properly connected, replace the ignitor.

Vermont Castings LHECDV30 Specifications

General

Model	LHECDV30
Manufacturer	Vermont Castings
Category	Indoor Fireplace
Type	Direct Vent Gas Fireplace
Fuel Type	Natural Gas or Propane
Venting	Direct Vent
Log Set Material	Ceramic Fiber
Ignition Type	Electronic Ignition
Voltage	120V
BTU Input	30, 000
Efficiency	70%
Finish Options	Black
BTU	30, 000