Page 1
VC400 ASSEMBLY
VC400 ASSEMBLY PROCEDURES
Tools Required: Knife or Scissors, Hammer, 7/16” (11 mm) wrench/ratchet or an adjustable wrench,
Step 1: Unpack carton
Use the knife or scissors to cut the strapping on the package then lift off the cardboard cap. Remove the
cardboard sleeve lifting it straight over top of the barbecue. Check the 5 enclosed parts kits, against the
parts list (Appendix A) to ensure that no parts are missing.
Philips or Robertson screwdriver.
VERMONT
C
astings
Box
#
1
VERMONT
Castings
Box
#
2
Box
#
3
Box
#
4
Box
#
5
VERMONT CASTINGS
To Next Page
Need help?
General
