Vermont Castings VC200

Questions and Answers

D
Derrick EvansJul 28, 2025
Why Vermont Castings VC200 Grill burner will not light?
- K
  Kyle ParksJul 29, 2025
  If the burner on your Vermont Castings Grill won't light, there are several potential causes: * The gas supply might be turned off. If so, turn on the fuel supply and try again. * You might be out of propane. Check the weight of your propane cylinder; a standard 20 lb cylinder weighs about 18 lb when empty and 38 lb when 80% full. * There could be a blockage in the gas system. Check the venturi tubes for obstructions like insects or debris, and clean them with a venturi brush. * The gas valve might be misaligned with the venturi tubes. Inspect under the front control panel and reinsert the gas injector into the venturi tube if needed. * The propane hose and regulator might not be properly attached. Tighten the regulator's plastic collar onto the cylinder valve by hand only.
L
Lori HodgesAug 2, 2025
What to do if Vermont Castings VC200 Grill won't stay lit?
- J
  jessica07Aug 2, 2025
  If your Vermont Castings Grill won't stay lit, consider these possible reasons: * Wind might be blowing it out. Shelter your grill from strong winds. * You might be running out of fuel. Weigh your propane cylinder to check; a full standard 20 lb cylinder should weigh about 38 lb, while an empty one weighs around 18 lb.
C
Cynthia RamosAug 6, 2025
What to do if Vermont Castings VC200 igniter does not spark?
- D
  Dennis JohnsonAug 6, 2025
  If the igniter on your Vermont Castings Grill isn't sparking, here are some things to check: * The electrode may be dirty. Wipe it with a soft, clean cloth. * The electrode gap may be incorrect. Gently bend the electrode tip into the correct position. * The electrode may be cracked. Replace it if the ceramic insulator is cracked. * The lead wire may be disconnected. Make sure it's well seated on the module. * The lead wire may be cracked. If so, replace it. * The battery may be dead or installed incorrectly. Ensure the positive end is down.
P
Patricia JacksonAug 10, 2025
Why Vermont Castings Grill unit won’t heat up?
- J
  Jonathan WalkerAug 10, 2025
  If your Vermont Castings Grill unit won’t heat up, it might be due to: * The control knob being left open at startup. Close the cylinder valve, ensure all burner control knobs are in the OFF position, then slowly open the cylinder valve (about 1 to 2 turns), wait 5 seconds, and try relighting a single burner. * Turning the gas on too quickly. Close the cylinder valve, confirm all burner control knobs are in the OFF position, open the cylinder valve slowly (about 1 to 2 turns) and wait 5 seconds. Finally, turn a single burner ON and try relighting it.
H
hannah32Aug 14, 2025
How to fix excessive yellow flame on Vermont Castings VC200 Grill?
- M
  mhoffmanAug 14, 2025
  If your Vermont Castings Grill has an excessive yellow flame, it could be due to an improper air shutter opening. First, inspect the venturi tubes for any obstructions and clean them. If the yellow flames persist, try adjusting the opening on the air shutter of the venturi tube, located under the grill's front console.
C
camposethanAug 19, 2025
What causes flareup on Vermont Castings Grill?
- L
  Laura BrooksSep 12, 2025
  Flare-ups on your Vermont Castings Grill can be caused by: * Excessively fatty foods. Trim excess fat from meat before cooking. * Grease buildup. Remove excess grease from the burn chamber.
X
xlambertAug 23, 2025
Why Vermont Castings Grill has uneven burn pattern or flashback fire?
- P
  Paul SandersAug 23, 2025
  An uneven burn pattern or flashback fire in your Vermont Castings Grill may be due to: * A blockage in the burner or gas system. Check the venturi tubes for obstructions and clean them with a venturi brush. * A corroded burner. See your Vermont Castings retailer for the appropriate replacement burner.

Summary

Warnings

Gas Leak Safety

Instructions for responding to gas leaks and general safety precautions.

Flammable Liquids Safety

Prohibits storing flammable liquids and unsecured LP cylinders near the appliance.

Understanding Signal Words

Defines signal words like DANGER, WARNING, CAUTION, and NOTE for safety interpretation.

Critical Safety Warnings

Highlights critical safety information regarding outdoor use and propane cylinders.

Safe Grill Locations

Specifies safe placement and clearance requirements for the outdoor grill.

Propane Gas Safety

Details safety precautions for using propane gas, including cylinder handling.

Natural Gas Safety

Provides safety guidelines for natural gas installation and use.

Safety

Burn Prevention

Offers advice on preventing burns while operating the grill, especially with children.

Grill Electrical Safety

Covers electrical safety requirements for accessories like the rotisserie motor.

Fuel Types and Usage

Explains safe fuel usage (propane vs. natural gas) and conversion.

Propane Cylinder Warnings

Provides additional crucial warnings for handling propane cylinders.

Gas Hookup

Connect LP Gas Supply

Step-by-step guide for connecting the propane gas supply to the grill.

LP Gas Connection Details

Instructions for connecting the propane tank and regulator to the grill.

Natural Gas Connection

Instructions for connecting the natural gas supply to the grill.

Gas Leak Testing Procedure

Procedure for testing gas connections for leaks before operating the grill.

Operation

Grill Control Functions

Describes the operation of the propane tank valve and burner control valves.

Electronic Ignition System

Explains how the electronic ignition system works and battery replacement.

Lighting Main Burners

Step-by-step instructions for lighting the main burners using igniter or match.

Turning Burners Off

Procedure for safely turning off the grill burners and gas supply.

Managing Flareups

Explains what flareups are and how to manage them during cooking.

Match Lighting Main Burners

Instructions for lighting the main burners using a match or lighter.

Lighting Oven Burner

Detailed steps for lighting the oven burner for convection cooking.

Lighting Rotisserie Burner

Instructions for lighting the rotisserie burner for poultry and roasts.

Match Lighting Rotisserie Burner

Procedure for lighting the rotisserie burner using a match or lighter.

Rotisserie Assembly Setup

Guide for setting up the rotisserie assembly, including counter-weight use.

Lighting Side Burner

Instructions for lighting and operating the side burner.

Shutting Off Side Burner

Procedure for correctly turning off the side burner without damaging the valve.

Using Smoker Boxes

How to use smoker boxes to add smoky flavor to food using wood chips or herbs.

Cooking

Cooking Methods Overview

Explains different cooking methods like direct, indirect, rotisserie, and side burner use.

Direct vs. Indirect Cooking

Details the direct and indirect cooking methods for grilling.

Food Preparation Safety

Provides essential food handling and preparation safety tips before grilling.

Expert Grilling Tips

Offers helpful tips for achieving perfect grilling results every time.

Care & Maintenance

General Care and Cleaning

General safety precautions for cleaning and maintaining the grill.

Burner Maintenance

Instructions for inspecting and cleaning the main burners and venturi tubes.

Rotisserie Burner Care

Guide for inspecting and cleaning the rotisserie burner.

Oven Burner Maintenance

Instructions for inspecting and cleaning the oven burner's air shutter screen.

Side Burner Maintenance

Guidance on inspecting and cleaning the side burner and its ignition electrode.

Cooking Grid Cleaning

Advice on cleaning the porcelain-enameled cooking grids.

Drip Tray Maintenance

How to access, check, and clean the grill's drip tray.

Stainless Steel Panel Care

Tips for cleaning and maintaining stainless steel surfaces without scratching.

Porcelain Enamel Care

Instructions for cleaning porcelain enamel surfaces to prevent damage.

Burner Air Shutter Adjustment

Procedure for adjusting air shutters to optimize burner flame patterns.

Warranty

Lifetime Component Warranty

Details the lifetime warranty coverage for exterior stainless steel components.

10-Year Surface Warranty

Outlines the 10-year warranty for porcelain onsteel surfaces and other parts.

5-Year Parts Warranty

Specifies the 5-year warranty for remaining parts.

1-Year Accessory Warranty

Covers the 1-year warranty for accessories like the rotisserie.