Why is the blower not on after turning on my Vermont Castings Indoor Fireplace?
If the blower isn't running after you turn on your Vermont Castings Indoor Fireplace, it might be because the blower setting is off. Press the FAN key to select the fan speed you want.
How to adjust the blower delay setting on my Vermont Castings WDV500NTSC Indoor Fireplace?
To adjust the blower delay setting on your Vermont Castings Indoor Fireplace, press and hold the FAN key to set the desired ON/OFF delays in minutes.
What to do if my Vermont Castings WDV500NTSC Indoor Fireplace appliance does not come on?
If your Vermont Castings Indoor Fireplace appliance isn't turning on, the transmitter might not be matched with the receiver. Ensure that the transmitter has learned to the receiver.
What to do if the Vermont Castings WDV500NTSC Indoor Fireplace transmitter measures temperature exceeding 99 degrees Fahrenheit?
If your Vermont Castings Indoor Fireplace transmitter shows 'HI' on the LCD and measures a temperature exceeding 99 degrees Fahrenheit, move the transmitter to a cooler location and wait for the temperature to drop below 99 degrees.
Why does the LCD display on my Vermont Castings WDV500NTSC Indoor Fireplace transmitter show a battery icon?
If you see a battery icon on the LCD of your Vermont Castings Indoor Fireplace transmitter, it likely means the battery is low. Replace the batteries, doing so every 6 months. Also, check the battery installation or reset the transmitter.
Why is the LCD display blank on my Vermont Castings WDV500NTSC Indoor Fireplace?
If the LCD display on your Vermont Castings Indoor Fireplace is blank, the battery may be low. Replace the batteries every 6 months. You should also check the battery installation or reset the transmitter.
Why does the LCD display show funny characters on my Vermont Castings Indoor Fireplace?
If the LCD display on your Vermont Castings Indoor Fireplace shows a 'funny' display, it likely indicates a low battery. Replace the batteries every 6 months. Also, check the battery installation or reset the transmitter.
Diagrams and measurements for WDV500 and WDV600 fireplace framing.
Required distances to combustibles for ceiling, sidewall, and mantel installations.
Safety rules for installers and actions that void the warranty.
Detailed steps for cutting holes and installing vent for sidewall termination.
Clearances for vent terminations in various locations like corners, alcoves, and balconies.
Instructions for installing vent termination below grade using a snorkel kit.
Approved vertical installations, height limits, and horizontal run considerations.
Instructions for using flexible UL1777 listed venting with the appliance.
Items needed and warnings for connecting the gas supply.
Recommended sediment trap installation and gas connection diagram.
Instructions for wiring the receptacle into an electrical circuit before framing.
Mounting the command center and routing cables.
Connecting and mounting the wall switch for low voltage control.
Wiring diagram and requirements for the blower kit.
Critical safety warnings before operating the fireplace.
Step-by-step guide to lighting the fireplace.
Procedures for safely turning off the gas supply to the appliance.
Setting up the system, including pilot modes and safety shutdowns.
Pairing the remote transmitter with the receiver.
Guide to LED indications for troubleshooting fireplace problems.
Low battery, thermal shutdown, and child-proof protection features.
Troubleshooting guide for the Signature Command System operation.
General| Brand | Vermont Castings |
|---|---|
| Model | WDV500NTSC |
| Category | Indoor Fireplace |
| Language | English |
To Next Page