Important
The machine MUST be bolted down before use. The machine should be run once
- empty - to prime the pipework.
Note:
For warranty, service or repair please quote the machine serial number which
can be found clearly marked on the rating plate which is positioned on the RH side,
bottom front of the machine.
4.7. Warning labels and icons – explanations
Please refer to the technical manual prior to installation, maintenance
or operation of this equipment.
Symbol indicates presence of 230/110 V 50/60 Hz
Start Cycle – Press this button to start the machine. An auto-start option is also
available. Contact Vernacare for more information
4.8. Cycle Counter
At the end of each cycle the LCD screen will briefly display the TOTAL cycle count for
the machine and also the SERVICE count which is the number of cycles since the
machine was last serviced.
The TOTAL cycle display counts every machine cycle and is not resettable (unless the
machine is reprogramed).
The SERVICE count is reset by the engineer when the machine is serviced. The
service count will also trigger a “Service” message on the LCD display once 5,000
cycles have been completed since the last service visit.
To Next Page
Loading...
