versa Quicktalk Go - Initial Assembly and Preparation Steps; 6.1 Charging the Battery; 6.2 Battery Pack Attachment and Removal

VERSA QUICKTALK GO SERVICE MANUAL
8
6. Initial Assembly and Preparation
6.1 Charging
Before charging the battery, make sure that the transceiver has been turned OFF. To charge the
battery, plug in to AC outlet (110-240Vac) and insert the bottom of the transceiver (with the
battery) into the charger. Orange LED light on the charger indicates that the battery is charging.
Green LED light indicates that the battery is fully charged. The battery reaches its maximum
capacity after 2 to 3 charging cycles.
Note: The battery may be charged either attached or removed from the transceiver. Never
charge the battery at temperature below -10°C (14°F) or above 35°C (95°F).
6.2 Battery Pack
To Attach: Fit the battery at the back of the transceiver and slide the battery. Click sound
indicates that the battery is locked.
To Remove: Make sure the radio is turned OFF. Press down the battery latch at the top of the
belt clip.