Need help?Do you have a question about the versa HERO and is the answer not in the manual?
General| Brand | versa |
|---|---|
| Model | HERO |
| Category | Two-Way Radio |
| Language | English |
Procedure for charging the battery using the AC outlet and indicator light status.
Instructions on how to attach and remove the battery pack from the transceiver.
Steps to install and remove the antenna by turning it clockwise or counterclockwise.
Instructions for fitting and screwing the belt clip to the back of the transceiver.
Guide to opening the earmic cover and connecting the earpiece.
How to turn on the transceiver and adjust the sound volume using the knob.
Instructions for using the PTT button for calls and receiving signals, including light indicators.
Details on long press for disabling CTCSS/DCS and short press for enabling the jack light.
Explains long press for emergency tone and short press for FM Radio activation.
Capability of transmitting and receiving on VHF and UHF frequency bands.
Allows radio programming via software and a programming cable.
Functionality for issuing warnings during emergency situations.
Enables voice-activated transmission, triggering PTT with voice.
Reduces interference by adding a low frequency (CTCSS/DCS).
Allows adjustment of the transmission time limit.
Automatically locks the radio after 10 seconds of inactivity.
Step-by-step guide for disassembling the radio, starting with antenna and knob.
Checking the physical condition of the radio's housing, knobs, battery, belt clip, buttons, and antenna.
Measuring RX sensitivity, TX power, and VSWR to ensure they are within specifications.
Verifying battery and charger voltage against specifications using a multitester.
Performing a short-range communication test.
Diagram illustrating the components and connections on the front board.
Diagram illustrating the components and connections on the back board.
Identifying defects in external parts like antenna, battery, belt clip, and housing.
Identifying defects in internal components like the mainboard, speaker, and LCD.
General requirements and installation of the Prolific USB to Serial Comm Port driver.
Steps to connect the radio, open software, set COM port, and read/write programming data.
Instructions for programming frequency, CTCSS/DCS, and saving/deleting channels via the keypad.
To Next Page
