ii
EN 4413 Hydraulic Fluid Power – General Rules and Safety Requirements for Systems and
Their Components
EN 12100 Safety of Machinery – General Principles for Design – Risk Assessment and Risk
Reduction
EN 13849-1 Safety of Machinery – Safety-Related Parts of Control Systems – Part 1:
General Principles for Design
EN 13849-2 Safety of Machinery – Safety-Related Parts of Control Systems – Part 2:
Validation
EN 13850 Safety of Machinery – Emergency Stop – Principles for Design
EN 13857 Safety of Machinery – Safety Distances to Prevent Hazard Zones Being Reached
by Upper and Lower Limbs
EN 60204-1 Safety of Machinery – Electrical Equipment of Machines – Part 1: General
Requirements
EN 60664-1 Insulation Coordination for Equipment within Low-Voltage Systems – Part 1:
Principles, Requirements and Tests
VDE 0682-742 Hubarbeitsbühnen zum Arbeiten an unter Spannung stehenden Teilen bis
AC 1000 V und DC 1500 V
The EU-Representative hereby declares that the aerial device has been examined and
tested and it is in compliance with the directives and standards referred to.
However, this partly completed machinery may NOT be put into service until it has been
installed on a carrier vehicle according to the advised methods in the Manufacturer’s
Installation Manual and the mounting specifications of the vehicle manufacturer, and the
completed MEWP has been declared in conformity with the provisions of aforementioned
directives and relevant standards by the Installer.
Place and Date: Farsø, 2018-02-20
Name: Breki Mar Luthersson, MIDA, BSc.
Position: Head of Type Approvals and Standards, TIME Export
To Next Page
Loading...
Need help?
General
