Vertex Standard DVS-9 User Manual

OperatiOn
r
 RotatetheVOL/PWRknobclockwisetoturntheVX-450on.
r
 Press(orpressandhold)theProgrammablekeywhichisprogrammedtothe“Option
SW2”functiontoactivatethe“ManDown”function.IntheVX-454/-459,the“ ”icon
willappearonthedisplay.
r
 WhentheVX-450(DVS-9)sensesthe“Man Down”action,suchasanoperatorfalls
down,theVX-450(DVS-9)operatesinaccordancewiththeprogrammingoftheCE104.
¦
 Youmaydisablethe alarmtonethatis generatedbythe“ManDown”functionby
pressingthePTTkey.However,the“ManDown”functionisstill“on”.
¦
 Youmaydisablethe“Siren”thatisgeneratedbythe“ManDown”function,bypress-
ingtheProgrammablekeywhichisprogrammedtothe“OptionSW2”function(Dis-
ablingthe“ManDown”function).
¦
 TheVX-450(DVS-9)whichisinthe“Stun”statusbythe“ManDown”functioncan-
not reviveby itself.RevivetheVX-450(DVS-9)bytheCE115ProgrammingSoft-
ware(Executethe“Upload”and“Download”functions).
¦
 Todisablethe“Emergency”functionthatwasactivatedbythe“ManDown”function,
turnofftheVX-450byrotatingtheVOL/PWRknobfullycounter-clockwise.
r
 TheVX-450(DVS-9)doesnotdetectthe“ManDown”actionagainwhensensinga“Man
Down”actiononce.Inthistime,restartthe“ManDown”functionbypressingthePro-
grammablekeywhichisprogrammedtothe“OptionSW2”functiontwice.
r
 Todisablethe“ManDown”function.Press(orpressandhold)theProgrammablekey
whichisprogrammedtothe“OptionSW2”functionagain.IntheVX-454/-459,the“ ”
iconwilldisappearfromthedisplay.
r
 RefertotheRECandPLAYsectionoftheVX-450seriesoperatingmanualfortheop-
erationoftheDigitalVoiceStoragefeature.
Man Down Alert with Digital Voice Storage Unit
DVS-9
Installation & Operation Manual
TheDVS-9isaManDownAlert/ Digital VoiceStorageUnit,whichmonitorsavarietyof
workertimedsafetyscenarios(ManDownAlertfeature)andallowsyoutorecordandplay
backincomingreceiveraudio(DigitalVoiceStoragefeature).
installatiOn prOcedure
r
 Makesurethatthetransceiveristurnedoff.Removethehardorsoftcase,ifused.
r
 RemovetheBatteryPackfromthetransceiver.
r
 TheconnectorfortheDVS-9islocatedundertheMetalCoverinthebatterycompart-
mentonthebackofthetransceiver.RemovethetwoscrewsafxingtheMetalCover,
thenremovetheMetalCoverfromthetransceiver.
r
 AligntheconnectoroftheDVS-9withthetransceiver’soptionboardconnectorandgen-
tlypresstheDVS-9intoplace.
r
 PeelofftheProtectiveSheetfromthesuppliedCushion Sheet, thenafxtheCushion
SheetinthepositionontheDVS-9whichisshownintheillustrationbelow.
r
 ReplacetheMetalCoverandits’twoscrews.
r
 Installationisnowcomplete.
DVS-9
MetalCover
CushionSheet
- 1 -- 4 -
Copyright2013
VertexStandardLMR,Inc.
Allrightsreserved.
Noportionofthismanual
maybereproducedwithout
thepermissionof
VertexStandardLMR,Inc.
Vertex Standard LMR, Inc.
Vertex Standard LMR, Inc.

Vertex Standard DVS-9 Specifications

General

Brand	Vertex Standard
Model	DVS-9
Category	Two-Way Radio
Language	English