Vertex Standard VX-3200U User Manual

FCC ID: K66VX-3200U-2/K66VX3200U-3
Alignment, Page 3/4
Vertex Standard Co., Ltd.
Alignment Channel Frequencies
UHF TYPE A
Channel Frequency
(simplex)
CTCSS
Encode
DCS
Encode
Narrow
/wide
Group 1 400.1MHz None None Wide
Group 2 415.1MHz None None Wide
Group 3 429.9MHz None None Wide
Group 4 400.1MHz None None Narrow
Group 5 415.1MHz None None Narrow
Group 6 429.9MHz None None Narrow
Group 7 415.1MHz 151.4Hz None Wide
Group 8 415.1MHz None 023 Wide
Group 9 415.1MHz 151.4Hz None Narrow
Group10 415.1MHz None 023 Narrow
UHF TYPE D
Channel Frequency
(simplex)
CTCSS
Encode
DCS
Encode
Narrow
/wide
Group 1 450.1MHz None None Wide
Group 2 470.1MHz None None Wide
Group 3 489.9MHz None None Wide
Group 4 450.1MHz None None Narrow
Group 5 470.1MHz None None Narrow
Group 6 489.9MHz None None Narrow
Group 7 470.1MHz 151.4Hz None Wide
Group 8 470.1MHz None 023 Wide
Group 9 470.1MHz 151.4Hz None Narrow
Group10 470.1MHz None 023 Narrow
UHF TYPE F
Channel Frequency
(simplex)
CTCSS
Encode
DCS
Encode
Narrow
/wide
Group 1 480.1MHz None None Wide
Group 2 496.1MHz None None Wide
Group 3 511.9MHz None None Wide
Group 4 480.1MHz None None Narrow
Group 5 496.1MHz None None Narrow
Group 6 511.9MHz None None Narrow
Group 7 496.1MHz 151.4Hz None Wide
Group 8 496.1MHz None 023 Wide
Group 9 496.1MHz 151.4Hz None Narrow
Group10 496.1MHz None 023 Narrow
PLL
PLL VCV
Connect the positive lead of the DC voltmeter to the test point TP1008 (VCV) on the RF-Unit, as
indicated in the figure, and the negative lead to chassis ground.
Set the transceiver to the high band edge frequency channel, then adjust coil L1016 on the Unit for
7.2V on the voltmeter.
Key the transmitter, and adjust coil L1018 on the Unit for 7.2V on the voltmeter.
Next select to the low edge frequency channel and confirm about 1.0V on the voltmeter.
Key the transmitter, and confirm about 1.0V on the voltmeter.

Vertex Standard VX-3200U Specifications

General

Brand	Vertex Standard
Model	VX-3200U
Category	Transceiver
Language	English