z
American National Standards Institute (ANSI) /
Institute of Electrical and Electronic Engineers
(IEEE) C95.1-1992
z
Institute of Electrical and Electronic Engineers
(IEEE) 95.11999 Edition
z
International Commission on Non-Ionizing
Radiation Protection (ICNIRP) 1998
z
Ministry of Health (Canada) Safety Code 6. Limits of
Human Exposure to Radiofrequency
Electromagnetic Fields in the Frequency Range
from 3 kHz to 300 GHz, 1999
z
Australian Communications Authority Radio
communications (Electromagnetic Radiation–
Human Exposure) Standard, 2003
z
ANATEL ANNEX to Resolution No. 303 of July 2,
2002 "Regulation of limitation of exposure to
electrical, magnetic and electromagnetic fields in
the radio frequency range between 9 KHz and 300
GHz" and "Attachment to resolution # 303 from July
2, 2002"
RF Exposure Compliance and Control
Guidelines and Operating Instructions
To control your exposure and ensure compliance with
the occupational/controlled environment exposure
limits, always adhere to the following procedures.
Guidelines:
z
Do not remove the RF Exposure Label from the
device.
z
User awareness instructions should accompany
device when transferred to other users.
z
Do not use this device if the operational
requirements described herein are not met.
Operating Instructions
z
Transmit no more than the rated duty factor of 50%
of the time. To transmit (talk), push the Push-To-Talk
(PTT) button. To receive calls, release the PTT
button. Transmitting 50% of the time, or less, is
important because this radio generates measurable
RF energy exposure when transmitting (in terms of
measuring for standards compliance).
z
Hold the radio in a vertical position in
front of the face with the microphone
(and other parts of the radio including
the antenna) at least 2.5 centimeters
(one inch) away from the nose or lips.
Antenna should be kept away from the eye.
Keeping the radio at a proper distance is important
since RF exposures decrease with increasing
distance from the antenna.
z
When worn on the body, always place the radio in a
Vertex Standard approved clip, The use of non-
Vertex Standard approved accessories may result
in exposure levels, which exceed the FCC
occupational/controlled environment RF exposure
limits.
Product Safety
5
To Next Page
Loading...
Need help?
General
