PWC – 450
PureWaterCooler
Copyright 2011 Vertex Water Products
4. Access Cold Tank
4.5 Place cold temperature sensor and top foam
together off to the side, as shown.
Remove screws from cold tank (8 plcs).
4.6 Using a flathead or similar tool, find the gap
located on the back right side of tank,
and pry the lid from the cold tank with a
twisting motion. Work around the edge
until the lid is loose.
4.7 Remove lid. The cold tank is now accessible.
4.8 Reinstall in reverse order.
cont.
To Next Page
Loading...
