Vertiv Liebert EXS - Unpacking and Inspection; Installation Tools; Removing the UPS from the Shipping Pallet

Vertiv | Liebert
®
EXS
™
, 10kVA Quick Start Guide | 4
2.0 UPS INSTALLATION AND
COMMISSIONING
2.1 Unpacking and Inspection
The Liebert™ EXS™ is shipped on a pallet. The UPS is equipped with casters that permit two or
more people to roll it off the pallet for installation. The Liebert™ EXS™ should be moved as close
as practical to its installation location before its packing is removed or the shipping brackets
loosened.
Inspect the UPS for damage. If any problem is found, file a damage claim with the carrier
immediately and send a copy to Vertiv™ at:
Vertiv™
1050 Dearborn Drive
P.O. Box 29186
Columbus, Ohio 43085 USA
Attn: Traffic Department
Check the accessories and model numbers against the delivery list. If any problem is found,
notify your local Vertiv™ representative immediately.
2.2 Installation Tools
The following tools are required to properly install your UPS:
• Pallet jack / Forklift
• Utility Knife
• 19mm (3/4 in.) open wrench or adjustable wrench (Crescent Wrench)
• 16mm (5/8 in.) wrench or socket
• 14mm (9/16 in.) wrench or socket
• 13mm (1/2 in.) wrench or socket
• #1, #2, and #3 Phillips-head screwdrivers
• Torque wrench
• Torque screwdriver
2.3 Removing the UPS from the shipping pallet:
1. Use a forklift, pallet jack, or other lifting device to move the packaged Liebert™ EXS™ as
close as practical to its intended installation location.
2. Remove the protective packing; see Figure 9.