Need help?Do you have a question about the Vertiv Liebert Mini-Mate MT036 and is the answer not in the manual?
General| Frequency | 60 Hz |
|---|---|
| Cooling Capacity | 36, 000 BTU/hr |
| Power Supply | 208-230V, 1-phase, 50/60 Hz |
| Refrigerant | R410A |
| Airflow | 1200 CFM |
| Humidity Range | 20% to 80% RH, non-condensing |
Guide for installing and using the Liebert Mini-Mate system.
Warning about electrical hazards during installation and maintenance.
Warning about high-pressure refrigerant system risks.
Warning about hazards from moving fan parts.
Warning about electrical shock from the controller.
Precaution for handling sharp components during installation.
Warning about burns from hot components during operation.
Explanation of the 25-digit model number configuration.
Detailed breakdown of each digit in the model number.
Diagram identifying components within the 4/5 ton evaporator unit.
Diagram identifying components within the 3 ton evaporator unit.
Unit dimensions and clearances, referencing submittal drawings.
Guidance on selecting an appropriate installation site for the unit.
Specific site selection criteria for outdoor units.
Procedures for connecting the system and setting it up.
Instructions for inspecting and safely handling the unit.
Provides detailed cabinet dimensions for 4 and 5 ton units.
Critical procedures for refrigerant line installation and charging.
Best practices for installing refrigerant piping for air-cooled systems.
Instructions on calculating and determining the correct refrigerant charge.
Step-by-step guide for low voltage field wiring.
Diagrams illustrating electrical field connections for 4/5 ton units.
Diagrams illustrating electrical field connections for 3 ton units.
Procedure for mounting the evaporator unit in a ceiling.
Steps for installing suspension rods and securing the unit.
Verification steps for electrical connections and safety.
Verification steps for refrigerant and drain piping.
Ensuring all installation steps are verified before start-up.
Procedure for documenting start-up for warranty validation.
Guidance for troubleshooting issues with the fan assembly.
Table detailing fault conditions and reset triggers for EC fans.
Procedures for maintaining the steam-generating humidifier.
Steps for replacing the humidifier's disposable canister.
Table of symptoms, causes, and remedies for humidifier issues.
Procedures for maintaining the TXV.
To Next Page
