Basic Operation of your Camera 12
en
11.2 Record video using the Camera
1. Hold down the POWER / MODE button 0 for
3 seconds to power ON the Camera.
The LED indicator lights up in blue.
2. Press the POWER / MODE button 0 to switch
to video mode.
Video mode indicator lights up in white.
3. Press the SHUTTER/SELECT button to start
recording video.
You will hear a beep sound. The blue LED
indicator and the white video mode indicator
flash when video recording is in progress.
4. Press the SHUTTER/SELECT button to stop
video recording.
The blue LED indicator and the white video
mode indicator stop flashing.
Note:
Videos will be stored on the Camera’s memory
card.
The Camera will issue a voice prompt to warn you
when the memory card is full.
If the Camera is running out of power, the video will
be saved before the Camera powers OFF.
Whether you are recording a video in bright sunlight
or a dimly lit room, you can change Camera
settings by selecting a specific mode via Hubble
Connect for VerveCam app. (see page 15)
To Next Page
Loading...