MIDI Time Code (MTC)
1. Press the UTILITY button until MIDI is selected. Use the Jog Dial to select
"StriPE" the Enter button.
2. Use the Jog Dial to select the desired MTC frame rate. Press the ENTER button.
3. The display shows "OFFSEt" . Press the ENTER button.
4. The display shows " 0 0 0".
Offset
When striping MTC, an offset time can be set. An offset is used to align the location
on the HDR and MIDI device. Unless the MIDI device requires some offset, the offset
time should be set to 00 00 00.
5. Use the Jog Dial to set the offset time. Press the ENTER button.
6. The display shows "SurE". Press the ENTER button.
7. The HDR generates and records the selected MTC signal on the dedicated sync
track, and stops when the end of the song is reached.
Display Mode
This function is used to control whether the mixer's bargraph display responds to
incoming MIDI messages or ignores them.
If set to "rESPnd" (Respond ), Continuous Controller messages will cause the
bargraph display and mixer control LEDs to show what setting is being adjusted
and display its value.
If set to "norESP" (NoRespond), the Continuous Controller messages will still control
the mixer, but the controls and values will not be displayed on the bargraph or mixer
panel. The normal setting is NoRespond.
1. Press UTILITY until MIDI is selected. Use the Jog Dial to select "disPLAY"
Press the ENTER button.
2. Use the Jog Dial to select either Respond or No Respond. Press the ENTER button.
3. The display shows "done", then the current location.
To Next Page
Loading...