SETTINGS BUTTON
The Settings button activates the setting menu. This is the menu for the pages
you can select and leave, such as inputs, outputs, protect, etc. Once you
choose your preferred default here, it will not change. To change your
selection, turn the dial, and press ENTER. The choices are as follows:
1. PROTECT
This protects your hard drive data. You must select "unprotect" to record or
edit. *Please protect your drive before powering down to avoid damage.
Press Enter
Choices are NO
YES
Pressing ENTER again selects.
2. INPUTS
This activates either the analog or digital inputs. If you are using the 1/4" or
XLR input, leave this on analog. If you are transferring digitally, set to digital.
Press ENTER
Choices are: Analog
DIGITAL
Pressing ENTER again selects
3 OUTPUT
This selects your output mode, either direct out (all 8 tracks direct out) or
Buss (all tracks summed to L/R Master out.)
Press ENTER
Choices are: direct
Buss
Pressing ENTER again selects.
4. SYNC
Selects the HDR sync setup.
Press ENTER
Choices are IntErn (Internal) normal setting. HDR runs by
itself, or Master with multiple units
Dig In follows digital input
slave Set here to follow other HDR's
LtCode Follows SMPTE from external source
(with SE-1 card)
LtSlav follows Master HDR, which is following
SMPTE, multiple units.
To Next Page
Loading...