8 SEND SYNC FUNCTION
This function is used to stop the sync signal in case the DAT recorder
uses "user bit" in SP/DIF digital format for another purpose and does
not start recording when it recognizes the change on "user bit". Some DAT
recorders, like TASCAM DA-3OMK2*, use the "user bit" for its own function.
If such a DAT recorder is used for mastering, the DAT recorder will not start
recording unless the sync signal is canceled.
The HDR-V8 stops the sync signal automatically in backing up, however it
needs to be switched not to send the sync signal manually when the DAT is
used for mastering by using SP/DIF digital interface.
Procedure to stop the sync signal
1. Press SETTING button and select "SEndSy" (send sync signal).
2. Turn dial to select "no" (stop sync signal)
4. Press ENTER button.
*TASCAM and DA-30MK2 is trade mark of TEAC Corporation.
MENU BUTTON
The Menu button brings up the menu pages for the categories that you will need
access to most often.
1) SONG
This page is where you will Recall a song, Create a song, or Delete a song.
Press MENU, turn dial to “SONG”, then press ENTER.
Turn dial to select Recall, create, or delete.
For RECALL, press ENTER
Turn dial to recall particular song number.
Press ENTER. Song is Recalled.
For CREATE, press ENTER
Turn dial to appropriate song number you are assigning.
Press ENTER
Length will appear. Press ENTER
Turn dial to desired song length.
Press ENTER
For DELETE, press ENTER
Select song number for song you are deleting.
Press ENTER
Sure appears. Press ENTER. Song is deleted.*
To Next Page
Loading...