HANDLEBAR BRACKET AND HEAD UNIT INSTALLATION
STEP 1
Attach the computer mounting bracket to the mounting band by sliding the disc on the
top of the mounting band into the slot provided on the bracket until it snaps into place.
STEP 2
Cut the plastic screw from the mounting band and place the mounting band on
the handlebar/stem with the mounting bracket facing up. Wrap the mounting
band around your handlebar/stem and through the slot on the other side of the
bracket, taking up as much slack as possible. Insert the screw into the slot as
shown and tighten the band with a screwdriver.
STEP 3
The head unit of the V-30 is designed to lock into its bracket. Slide the
computer from the front to the back until you hear an audible “snap” indicating
the unit is locked firmly in place.
STEP 4
Adjust the unit on the handlebar/stem until you are satisfied with its position,
then tighten the screw until the mounting band is secure.
To Next Page
Loading...
