AUTO SCAN
The Vetta V-30 computer is programmed to automatically scan between the trip distance and total
distance readings on the bottom line of the dual display. Current speed is displayed at all times in large
digits on the top line of the display.
AUTO POWER SAVING MODE (AUTO START-STOP)
When you stop using the computer for 10 minutes (no signal input for 10 continuous minutes), the
display will disappear and the unit will automatically go into power saving mode. When the unit begins to
receive a signal again (wheel in motion) it will automatically switch from power saving mode and
display all functions.
AUTO DATA CLEARING
When the computer is not used for 6 hours, all of the current trip distance data stored in memory will be
erased. Wheel circumference and cumulative odometer data will be retained. When the computer is used
next, speed and trip distance will commence from zero.
FEATURE LIST
To Next Page
Loading...
