INSTALLATION TEST
Once you have finished with the installation procedure, you are ready to test the unit to make sure that it works.
STEP 1
Make sure that the computer head is locked firmly into the mounting bracket.
STEP 2
Pick up the front of the bicycle and spin the front wheel. The computer should register speed within 1-2
seconds. If you do not get a speed reading, check to be sure that the magnet and sensor alignment is
correct and that the space between the magnet and sensor is 1-2mm or less. If this does not solve the
problem, talk to your Authorized Vetta Retailer. In the United States Vetta customers can call our service
hotline at 1.800.GO.VETTA.
To Next Page
Loading...
