Vetus BOW PRO Series User Manual (English)

Other manuals for Vetus BOW PRO Series

Owner's Manual22 pages

User Manual32 pages

Questions and Answers:

P
Paul JordanAug 3, 2025
How to troubleshoot Vetus BOW PRO when the electric motor does not operate?
- N
  Noah HernandezAug 3, 2025
  If the electric motor of your Vetus Outboard Motor does not operate, there are several things you can check: * Ensure the battery main switch is in the ‘ON’ position. * Verify the battery voltage is correct (10.5 - 14.4 V for a 12 V bow thruster, 21.0 - 28.8 V for a 24 V bow thruster, or 42.0 - 57.6 V for a 48 V bow thruster). * Inspect the control current fuse and the CAN bus power supply fuse to see if they have blown. * Check the main supply fuses. * Confirm that the propeller can turn freely. If an overload has occurred, wait for the controller to cool down until the LED turns green, then the bow thruster can be used again.
K
katherine16Aug 9, 2025
What to do if the electric motor rotates, but there is no thrust in my Vetus Outboard Motor?
- H
  hayleythomasAug 9, 2025
  If the electric motor of your Vetus Outboard Motor rotates but produces no thrust, it could be due to: * Damage to the propeller blades caused by a foreign object. Replace the drive pin and inspect the propeller hub for damage. * A broken drive pin on the propeller shaft, also likely due to a foreign object. Replace the drive pin and check the propeller hub for damage.
A
alewisAug 15, 2025
Why is the electric motor of my Vetus BOW PRO Outboard Motor turning slowly?
- S
  Seth SimonAug 15, 2025
  If the electric motor of your Vetus Outboard Motor is turning slowly, it might be because the motor or regulator has become too hot, causing the motor to run at reduced power. Alternatively, weed or fishing line might be caught in the propeller.
J
Jeremy PenningtonAug 21, 2025
What causes the control panel fuse to blow in my Vetus BOW PRO Outboard Motor?
- J
  James BrownAug 21, 2025
  If the control panel fuse of your Vetus Outboard Motor keeps blowing, it is likely due to a short circuit in the operating circuit. You should check the wiring to resolve this issue.
R
Robert JacksonAug 27, 2025
What to do if after pressing the on/off switch on the panel, the panel does not switch on Vetus Outboard Motor?
- T
  Tammy WalkerAug 27, 2025
  If the panel of your Vetus Outboard Motor does not switch on after pressing the on/off switch, ensure that you press the on/off switch a second time within 6 seconds. Also, check that the joystick is in the middle position when pressing the on/off switch.