113°F (45°C).
3. While charging, the charger may hum and become warm to the touch. This is a
normal phenomenon and does not indicate a problem.
4. If the batteries do not charge properly—(1) Check the current at the receptacle
by plugging in a lamp or other appliance. (2) Check to see if the receptacle is
connected to a light switch that turns the power off when you turn out the lights. (3)
Move the charger and tool to a surrounding air temperature of 40°F (4.5°C) to
105°F (+40.5°C). (4) If the receptacle and temperature are OK, and you do not get
proper charging, take or send the tool and charger to your local service center.
See Tools Electric in the yellow pages.
5. The tool should be recharged when it fails to produce sufficient power on jobs
that were easily done previously. Battery life may be greatly diminished if batteries
are discharged deeply. DO NOT CONTINUE using the product with its batteries in
a depleted condition. Recharge discharged batteries promptly.
6. To maximize battery life:
a. Do not fully discharge batteries.
b. Fully recharge batteries after each use.
c. Store the tool in a location where the surrounding air temperature is
approximately 40°F-75°F (4.5°C - 24°C).
d. Disconnect the charger from the tool after the charge is complete.
WARNING: Fire Hazard. When disconnecting the charger from the tool, be sure to
unplug the charger from the outlet first, then disconnect the charger cord from the
tool.
To Next Page
Loading...
