CHARGING PROCEDURE
IMPORTANT: The battery pack is not fully charged at the factory. Before
attempting to charge them, thoroughly read all of the safety instructions.
(1) To ensure that the charger you use is applicable to the battery pack.
(2) Plug the charger plug into the charging hole of the battery pack.
(3) Plug the charger into any suitable standard outlet.
(4) Let the battery pack charge initially, for the green light is twinkled. If the power
lights are all lighting, the battery pack is fully charged.
Recharge discharged batteries as soon as possible after use or battery life
may be greatly diminished. For the longest battery life, do not discharge
batteries fully.
It is recommended that the batteries be recharged after each use.
WARNING: Fire Hazard. When unplugging the output plug from the charging hole,
be sure to unplug the charger from the outlet first, then disconnect the charger
output plug from the charging hole.
Important Charging Notes
1. Your tool was sent from the factory in an uncharged condition. Before attempting
to use it, it must be charged.
2. CAUTION: To reduce the risk of damage to the batteries, NEVER charge them
in an air temperature below 40°F (4.5°C) or above 105°F (40.5°C). Also, NEVER
charge them if the battery temperature is below 40°F (4.5°C) or above 105°F
(40.5°C). The longest life and the best performance occur when batteries are
charged with an air temperature of approximately 75°F (24°C). NOTE: The tool will
not charge if the tool temperature is below approximately 32°F (0°C) or above
To Next Page
Loading...
