Flow alarm (red light
on the panel) Use
the water pipes
directly
The water level storage tank
is too low
Check the water level gauge display.
Add water to the level shown in the
green area: and check the water
circulation pipe for leaks.
Connect to the
water outlet and
inlet though There
is still no flow
The water circulation pipe is
clogged or the pipe is bent
and deformed
Check the water circulation pipes
Ultra-high
temperature alarm
Clogging of dust gauze,
poor heat dissipation
Unplug and wash the dust gauze
regularly
Poor ventilation of air outlets
and air intakes
Make sure the air outlets and air
intakes are well ventilated
The voltage is extremely
low or unstable
Improve the power supply circuit or
use a voltage regulator
Ultra-high room
temperature alarm
The operating environment
temperature is too high
Ensure that the machine runs below
40°C
Drain slowly when
changing water
The eject port is not open
①.Industrial chillers×1
②.User manual×1
③.Power cord×1
④.Sealing hoops×2
⑤.Alarm signal output plug×1
To Next Page
Loading...
