EasyManua.ls Logo

VEVOR DT2W - Firepower Adjustment and Shutdown; Child Lock and Timing Function; Panel High Temperature Warning; Temperature Settings

VEVOR DT2W
6 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5. Firepower adjustment: in heating mode, push the regulator, the digital gear
from 1 to 9 is normal heating gear, and the P gear is rapid heating. After 3
minutes, it will return to the 9 gear. Turn to 0 to stop heating.
6.Shutdown: In heating mode, long press the power button (long press
for two seconds) to exit heating and return to shutdown state.
7.Child lock: long press the child lock key 2--3 seconds to drop a sound to
lock or unlock, locked successfully child lock digital display Lo, shutdown or
standby with heating state can operate child lock. After successfully locking,
do not operate any health except child lock.
Locked successfully as shown in figure:
8.Timing: This function is to set the shutdown time. In heating mode, press
the timing button to enter the preset timing. The default time is 00 minutes.
Button adjusting time (progressive 1 minute, 99 minutes at most),
stop operation after adjustment, digital flashing several times into t h e
steady setting success. Continuously press the timing button to set the time
of multiple furnace areas. After the setting is completed, the small dot
ashes at the lower right corner of the display digital number in the
furnace area. The time display in different furnace areas automatically
switches to about 5 seconds, with the small dot as a mark.
A s shown in the picture, timing left upper furnace area: 99 minutes
9. Panel high temperature warning: there is still residual temperature on the
furnace panel after use, warning display H, be careful of scalding hands.
10.The temperature corresponding to each section of fire (set the numerical
value for the program), the measured data obtained by different working ring
mirrors will have deviation.Range 1--2--3--4--5--6--7--8--9--P ten stages.
Corresponding degrees Celsius:
100-140-180-210-240-320-400-480-520-600 ten section
(sensor control parameters in furnace tray).
Corresponding to 212-284-356-410-464-608-752-896-968-1112F
ten section (sensor control parameters in hearth).
All flat bottom pots.
Please use iron pot, containing magnetic pot.
Please limit your food within 4kg.
3
4