VEVOR DZ600-2S-V1 User Manual (English)

Questions and Answers:

M
Mr. Daniel Little DVMAug 7, 2025
Why is the vacuumizing speed slow on my VEVOR DZ600-2S-V1?
- I
  ipittmanAug 7, 2025
  If your VEVOR Kitchen Appliances vacuum sealer isn't achieving the best vacuum state or the vacuumizing speed is slow, there are a few potential causes. First, the vacuumizing time may be too short, so try extending it. Second, the oil in the vacuum pump might not be sufficient or clean; check the oil level, refuel, or change the oil, paying attention to the oil type (vacuum oil 46#, 68#) and quantity. Finally, air leakage or wear of the sealing ring could be the issue; in this case, replace the sealing ring.
J
James FreemanAug 17, 2025
What to do if my VEVOR Kitchen Appliances are experiencing sealing failure?
- M
  moorerachaelAug 17, 2025
  If you're experiencing sealing failure or poor sealing with your VEVOR Kitchen Appliances, consider these potential causes and solutions: * Ensure the bags are correctly placed on the heating plates. * Adjust the sealing time; it may be too long or too short. * Verify that you're using an appropriate heating temperature. * Inspect the silicon strip for damage or impurities; clean or replace the silicon rubber if needed. * Check the electric heating wire for damage and replace it if necessary.
K
Katherine RiosAug 27, 2025
What to do if VEVOR Kitchen Appliances control panel starts but the machine doesn't work?
- J
  Jason ReeseAug 27, 2025
  If the control panel of your VEVOR Kitchen Appliances starts up, but the machine itself doesn't work, it might be because the parameter is being set. Make sure to complete the parameter setting.