dissolve. The oxidationreduction reaction of cathode and anode is as
follows
2H2O+2e-= 2OH- + H2 Alkaline electrolytic water with reductive
E0=0-0.0591pH
H2O= 2H+ + 1/2O2 + 2e- Acidic electrolytic water with oxidative
E0=1.228-0.0591pH
After the hydrogen and oxygen are produced on the surface of the cathode
and anode, the water around the electrodes become alkaline and acidic. At
the same time, the ORP are changed. The porous semipermeable
membrane or the semipermeable membrane that Cation-anion can
selective to go through will be insert into the two poles to limit the water.
The acidic water with high concentration and oxidative will be collect from
positive pole, the alkaline water with high concentration and reductive will
be collect from negative pole. This is the operation principle of water
ionizer.
Before using this water ionizer, please read these precautions
carefully. Please operate this water ionizer following the precautions
to avoid the damages to the machine or your health.
• City or municipal water is recommended. Well water or ground water
which contains impurities, chemicals and heavy metals is not
recommended.
• Please replace the water filters timely, to assure the water quality is good
for your health and machine's lifespan.
• Don't connect it with a water heater. Make sure the inlet water
temperature is below 113 Fahrenheit degrees (45 Celsius degrees). Keep
the machine away from high temperatures and direct sunlight.
• Don't use water to rinse the machine directly, and don't use alcohol and
other volatile solvents to wipe it, either. Please use a soft cloth with soapy
water to wipe it gently.
• Don't use the aluminum or copper container for the alkaline or acidity
To Next Page
Loading...