water, as the water could be contaminated by these types of containers.
• Don't disassemble the machine & components. Don't block, fold or break
the outlet tube. When the machine is working, for the purpose of expelling
water freely, don't keep the Drain water outlet tube in a high place. And the
Drain water tube should be no more than 60cm in length.
• Every morning before collecting alkaline water from the ionizer, allow the
water to run for 10~30 seconds to fl ush out the water in the machine and
filters. And the end of the day, it is suggested to flush for 10-15 seconds in
the “ Purified water” level and “ Sanitizing ” water level to prevent scaling.
• The ionized alkaline & acidic water should be used as soon as possible
within 24 hours.
• Don't take medicine with alkaline water. Please use purified water.
• Don't drink acidic water.
• Please disconnect the power plug when not using the machine for long
period.
Issue 1: The power supply light is not on or LCD screen does not display.
Solution: please check electricity power supply is connected properly and
re-plugin the cord.
Issue 2: Touch control panel does not function or respond (but the
machine can still work normally).
Solution: Please unplug the power cord and wait a minute, then plugin the
power cord. After the power is re- applied, the unit should return to normal
operation. Note: Do not share the power supply with a large power
appliance. Do not locate the ionizer near electromagnetic radiation
appliances, i.e. microwave ovens.
Issue 3: Background light on LCD is not on and the LCD is dark, when
water passes through.
Solution: The tap water pressure is LOW ( Less than 0 . 8L/ minute water
output), please increase the water pressure and check if the filter blocked
To Next Page
Loading...