Note: In alkaline water levels, when turning down the water flow rate to
lower than 0.8L/minute, the ionizer will start auto-cleaning (LCD turns red).
After 10 seconds the auto-cleaning will stop, and the LCD turns blue and
the ionizer will enter standby mode. If there is no operation within 1 minute,
the LCD will turn out.
Do not turn on the water tap when you are going to set the machine.
1.Water temperature setting:
Press and hold the Drinking water button for 5 seconds to enter the
temperature setting. Adjust the readings by pressing the Cleaning button to
increase, and Heating button to decrease.
2.Time setting:
Press and hold the Coffee / Tea water button for 5 seconds to enter the
time setting. Adjust the readings by pressing the Cleaning button to
increase, and Heating button to decrease. After setting up the hour, press
the Coffee / Tea water button again to set up the minute. Press the Coffee /
Tea water button to save the setting and exit to standby state.
3.PH level setting:
Press and hold the Cooking water button for 5 seconds to enter the pH
level setting. You can set up 1-2-3 for low, middle and high electrolysis
strength. Adjust the readings by pressing the Cleaning button to increase,
and Heating button to decrease. Then press the Cooking water button to
save the setting and exit to standby state.
4.Filter lifespan setting:
Press and hold the Skin Washing water button for 5 seconds to enter the
filter lifespan setting. The filter life setting range is 1000L to 9000L. Adjust
the readings by pressing the Cleaning button to increase, and Heating
To Next Page
Loading...