Tee assembly 1/4”PE pipe 3/8" soft pipe
Accessory bag Power cord pH test reagent
Note: If there is any improvement, it will be clarified in this manual. The
product's appearance, color changes and specifications are subject to
modification without notice.
2. Installation Environment
A. Install the machine in a place that will avoid the direct sunshine and the
fire (Over 1 Meter).
B. This water ionizer is using AC120V or AC220-240V power supply.
Please connect it to a separate power socket, and away from other
appliances, such as microwave oven. To ensure safety, the ground wire is
needed.
C. This water ionizer works with 0.1-0.3MPa water pressure. If your input
water pressure is lower than o.1MPa, please install a booster pump.
3. Installation Tools You May Need
A. Cross Screwdriver B. Cutting Knife C.PTFE tape
4. Installation Diagram Overview
To Next Page
Loading...