What to do if my VEVOR FLO500 motor is not switched on?
If the VEVOR Water Pump motor isn't starting, first ensure the power supply is switched on. If it is, and the pump still doesn't start, the plug may be defective and require repair. Also, the issue might stem from a motor or sensor malfunction; in this case, remove the lid, flush it clean, and dry the sensor thoroughly with a hair dryer.
Why does my VEVOR Water Pump run non-stop or for a long time?
If the VEVOR Water Pump engine runs non-stop or for extended periods, first, check the drain installation. Ensure that the height or length of the drain isn't excessive and that there aren't too many bends. Also, the pump might be blocked. If so, turn off the power, disassemble the pump, and remove any blockages.
What to do if my VEVOR FLO500 Water Pump occasionally starts to work?
If your VEVOR Water Pump only starts occasionally, it may be due to leaking pipelines. Check the installation in front of the appliance. Alternatively, the check valve could be leaking. In this case, try cleaning or replacing the check valve.
Why is my VEVOR FLO500 Water Pump motor rattling with a noise?
If the VEVOR Water Pump motor is rattling and making noise, there might be a foreign object inside. Remove the lid, clean the area, and remove any object. If the noise persists, the condenser may be broken or there may be motor trouble, it is best to contact a qualified specialist or the supplier.
Item A-B: check valve with plastic elbow.
Items C, G, H: Various sizes of hose clamps (32-50mm, 90-110mm, 110-120mm).
Item D: Rubber ring for connecting toilet and pump.
Item E: Plastic hose accessory.
Item F: Activated Carbon accessory.
Items J (Lid) and K (Plug, mounted on pump).
500W input power rating and 220-240V, 50HZ input voltage.
110L/MIN flow rate and 8M vertical, 80M horizontal lift.
Max temperature 90°C, noise level 45 dBA, IPX4 degree of protection.
Unit must be installed to current electrical regulations by a registered electrician.
Use radius bends, avoid 90-degree elbows for pipe runs.
Water pipe must have a 1% inclination for horizontal discharge.
Unit accepts one input (toilet, shower, sink) with blanking covers.
Connection by qualified technician, follow rules, replace damaged power cords.
Appliance switches off when overheating; close water supply during absence.
Failure to follow indications may cause personal security risks.
Use only for human excrement+toilet paper; improper use voids warranty.
Check pipelines and check valve for leaks.
Check for blocked aerator in the lid.
Check drain height, length, bends, or pump blockages.
Verify power supply and check plug for defects.
Inspect motor for foreign objects.
Check condensator or inspect motor for foreign objects.
General| Brand | VEVOR |
|---|---|
| Model | FLO500 |
| Category | Water Pump |
| Language | English |
To Next Page
