What to do if my VEVOR Water Pump motor is not switched on?
If your VEVOR Water Pump motor isn't turning on, first ensure the power supply is switched on. If that's not the issue, check the plug for any defects and repair it if necessary. Additionally, inspect the motor or sensor by removing the lid, flushing it clean, and drying the sensor.
Why does my VEVOR FLO300 Water Pump occasionally start to work?
If your VEVOR Water Pump occasionally starts, it could be due to leaks in the connected pipelines. Check the installation in front of the appliance. Another possible cause is a leaking check valve, which should be cleaned or replaced.
Why does my VEVOR FLO300 engine run non-stop or for a long time?
If your VEVOR Water Pump engine runs non-stop or for extended periods, examine the drain installation, ensuring the height or length isn't excessive and that there aren't too many bends. Also, the pump may be blocked. In this case, turn off the power, disassemble the pump, and clear any blockages.
Why is my VEVOR Water Pump motor rattling with a noise?
If your VEVOR Water Pump motor is rattling with noise, it might be due to a foreign object inside. To resolve this, remove the lid, clean the pump, and remove any foreign objects. If the noise persists, it could be a faulty capacitor or motor issue, which requires assistance from a qualified specialist or the supplier.
What to do if VEVOR FLO300 Water Pump motor runs properly, but the water runs slowly away?
If the motor of your VEVOR Water Pump is running properly, but the water runs slowly, it could be due to a blocked aerator in the lid. Clean the aerator to resolve this issue.
Lists all included accessories for product installation.
Provides detailed, step-by-step instructions and visual aids for setting up the pump.
General| Brand | VEVOR |
|---|---|
| Model | FLO300 |
| Category | Water Pump |
| Language | English |
To Next Page
