What to do if my VEVOR 2KQ-3G Water Pump is spraying oil?
If your VEVOR Water Pump is spraying oil, it could be due to a couple of reasons. First, check if there's too much oil in the pump; if so, adjust the oil level to the recommended level. Alternatively, the gas inlet pressure might be too high, or too much gas has been pumped. In this case, consider using a bigger pump or reducing the gas inlet pressure.
Why does my VEVOR 2KQ-3G Water Pump have a low degree of vacuum?
A low degree of vacuum in your VEVOR Water Pump can stem from several causes. First, ensure there's sufficient oil; if not, add oil up to the oil level line. Second, check the oil's condition; if it's dirty, replace it. Third, inspect the oil intake for blockages and clean it or the filter if necessary. Fourth, examine the hose or gas inlet for clogs and clear them. Finally, verify that the pump is suitable for your specific application; if not, acquire a more appropriate pump.
What causes oil leaks in a VEVOR 2KQ-3G?
If your VEVOR Water Pump is leaking oil, there are a couple of potential causes. The oil seal might be damaged, requiring a replacement. Alternatively, the housing gasket could be loose or worn out, which would also necessitate replacement.
What to do if my VEVOR 2KQ-3G Water Pump has starting difficulty?
If you're experiencing difficulty starting your VEVOR Water Pump, it could be due to the oil temperature being too low. Try starting the pump multiple times to warm the oil.
Guidelines for safe operation, including oil use, gas temperature, voltage, and plug handling.
Do not pump flammable, explosive, or poisonous gases. Use PPE for hazardous materials.
Details dual-stage rotary vane design, gas ballast, copper coil motor, aluminum body, and anti-flow design.
Lists the items included in the package for each model (pump, oil bottle, manual).
Guides on filling oil, connecting hoses, removing exhaust cap, and powering on.
Positioning, clearance, mounting, and connecting the pump to the system being evacuated.
Keep pump clean, maintain oil level, and replace dirty oil.
General| Model | 2KQ-3G |
|---|---|
| Category | Water Pump |
| Frequency | 50Hz |
| Max. Head | 32m |
| Max. Suction | 8m |
| Speed | 2850 RPM |
| Protection Grade | IP44 |
| Material | Cast Iron |
| Type | Centrifugal |
| Power | 370W |
| Max. Flow Rate | 35 L/min |
| Inlet Diameter | 1 inch |
| Outlet Diameter | 1 inch |
To Next Page
