What to do if my VEVOR FLO700 Water Pump motor is not switched on?
If the VEVOR Water Pump motor isn't starting, first ensure the power supply is switched on. If it is, and the pump still doesn't start, the plug may be defective and require repair. Also, the issue might stem from a motor or sensor malfunction; in this case, remove the lid, flush it clean, and dry the sensor thoroughly with a hair dryer.
Why does my VEVOR FLO700 Water Pump run non-stop or for a long time?
If the VEVOR Water Pump engine runs non-stop or for extended periods, first, check the drain installation. Ensure that the height or length of the drain isn't excessive and that there aren't too many bends. Also, the pump might be blocked. If so, turn off the power, disassemble the pump, and remove any blockages.
What to do if my VEVOR Water Pump occasionally starts to work?
If your VEVOR Water Pump only starts occasionally, it may be due to leaking pipelines. Check the installation in front of the appliance. Alternatively, the check valve could be leaking. In this case, try cleaning or replacing the check valve.
Why is my VEVOR Water Pump motor rattling with a noise?
If the VEVOR Water Pump motor is rattling and making noise, there might be a foreign object inside. Remove the lid, clean the area, and remove any object. If the noise persists, the condenser may be broken or there may be motor trouble, it is best to contact a qualified specialist or the supplier.
How to fix slow water flow in my VEVOR Water Pump?
If the VEVOR Water Pump motor is running but water flows away slowly, the aerator in the lid might be blocked. Try cleaning the aerator to resolve this issue.
Note on factory testing and potential residual water in the appliance.
Describes the macerator pump's suitability for indoor use and horizontal outlet toilets.
Visual guide showing pipe connections and layout for the sewage pump installation.
Enumerates all supplied parts and fittings necessary for the installation process.
Step-by-step guidance for connecting pipes, hoses, and ensuring proper pump setup.
Specific instructions for connecting the sewage pump to shower room and sink inlets.
Explains setup for activated carbon and ventilation for odor control.
General| Model | FLO700 |
|---|---|
| Category | Water Pump |
| Cable Length | 10m |
| Max Submersion Depth | 7m |
| Max Particle Size | 35mm |
| Type | Submersible Pump |
| Power | 750W |
| Voltage | 110V |
| Outlet Diameter | 1 inch |
| Impeller Material | Thermoplastic |
To Next Page
