e．Installation of pump cover, fastener
and pump tube
①. Put the pump cover on the bearing
and keep the pump tube in the center
of the tank.
②. Slide the fastener toward the back
of the pump cover and under the head
off the bearing until the neck of the
spindle is completely in the locking
keyway. Turn the fastener1/4 circle
(clock-wise) to lock and release,
then turn 1/4 circle (anti-clock-wise) to
take out the fastener.
③. Put the pump tube into the hole of the pump cover and ensure it fixes tightly.
g．Pour proper amount of water to the
tank , in order to check if there is leakage
in the base of the evaporator and
dispensing hole. If there is leakage, please
repeat the third and fourth step, then cover
the tank cover.
(4) Clean the machine
a. Disassemble the tank assembly, use neutral downy detergent mix with warm
water to wash the parts, use cleaning cloth without tomenta to dip detergent to
wash machine.
b. Use clean flowing water to wash these parts again, and use cleaning cloth
without tomenta to dip water to wash machine again.
c. Use dry cleaning cloth without tomenta to dry the parts.
To Next Page
Loading...
