d. Use detergent to wash drip tray and drip tray cover, then use pure water to
wash them again, after that, install the drip tray on the front panel, and also put the
drip tray cover on the drip tray
(5) Plug in
The socket and other appliance should comply with user’s local electrical
regulations and national rules, also the voltage and current should comply with the
rated value according to nameplate, (if use external plug, should use connection
board with right current)，and the machines should be properly grounded. If the
voltage ranges too much(beyond the rated value ±10%), it may cause the machine
can not start, or break the PCB board, or break compressor. In this condition,
adding a appropriate voltage stabilizer is necessary.
B. Testing
When the tank is installed well, firstly pour in a little drinking water. Check the
bottom of the tank and dispensing mouth, if there is a slight leakage on the bottom
of the tank, use your hand diagonally to take the tank and press downward, to
make sure the tank and O-ring into the right place; if there is leakage on the
dispensing mouth, please check the O-ring is in proper place, or change it if it is
necessary. Then add beverage into the bowls and switch on cooling.
(1) Ingredients include : dried fruit powder, syrup or plum juice and drinking water,
mix the fruit juice and the drinking water according to certain proportion (for
delicious advisable). Stir mixed liquor completely in a clean container, and
particles are not allowed; otherwise the dispensing mouth will be blocked.
(2) The temperature of mixed liquor cannot exceed 35℃.
(3) Please remember that do not use too thick juice or drink with precipitate,
otherwise easily result in water pipe blockage, and not pumping water
properly.
Warning: connect or use drinking water, the formula materials should
conform to the requirements of the food hygiene license.
To Next Page
Loading...
