Spray type
a．Fix the bearing sleeve onto the bearing,
and then put the impeller mounted on the
bearing sleeve, with the blade side up.
b．Fix the sealing ring to the bottom of the
evaporator, ensure that the sealing and
evaporator fits tightly. During this process,
dip the sealing ring with some water or
vaseline, which will help further installation.
c．Install the tank to the supporting block, hold
the tank diagonally and press downward
evenly, if succeed, the tank will locked on the
right position and will not tilt.
d．Installation of dispensing valve and handle
① Wear the dispensing valve with O-ring and turn the O-ring to the right position.
② Fix the handle into the two "V" slot and push the handle inside the slot.
③ Lower the dispensing valve (do not drop in) down through the valve hole and
the hole in the handle. When the valve is seated on its O-ring, release the handle.
④ Push the handle in and release it several times to ensure the valve move up
and down freely.
To Next Page
Loading...
