1. The bowls assembly should be cleaned everyday.
2. D-ring and O-ring should be checked after cleaning and replaced if worn.
3. In case of parts heat cracking, with high temperature disinfection is prohibited
and do not use more than 60 C boiled water to clean the tank and components.
B. Maintenance
Use a cleaning cloth or brush to clear away all the dust and attachments on the
surface or inside of the machine regularly. Do not flush the interior of machine with
water directly. Before cleaning, please cut off the power and disconnect the plug; it
is essential.
(1) Cut off the power first, and disassemble all the panels of the machines, then
clear the dust attached to the compressor, copper pipe, and bottom panel.
Using water is forbidden.
(2) After being used over a period of time, the condenser maybe thick with dust,
and this will affect radiating heat and cause bad cooling, so it needs periodic
cleaning (every half year)
(3) Step 1: Disconnected the main power switch.
(4) Step 2: Remove the back panel and side panels.
(5) Step 3: Clean dust with tools such as a vacuum cleaner, high-pressure air,
and hairbrush, be careful while cleaning to avoid damaging the condenser's
fins.
(6) Check all the screws and nuts if they are loose or rusty, and fasten or
replace them to avoid causing noise.
(7) Finally, assemble all the panels, fasten all screws, and clear the surface.
The following table lists showed the possible machine fault and its reason and
processing method. For general simple fault, can follow the table processing
method and processing, such as the fault is still cannot be ruled out, as well as
more complex fault, please contact professional maintenance staff immediately,
never sloppy handling, so as not to bring you unnecessary loss.
To Next Page
Loading...
